K1C pauses for a few seconds while changing printing mode (speed)

[vtech88]

I bought a Creality K1C last week and have been playing with it (I also own a Tevo tarantula)
The printer has updated its firmware via wifi once I connected to my home network. (running 1.33.29)

One of the issues that is annoying me is that the printer defaults to Standard (100%) speed and when I change it to Stable (50%) or Silent because I want a slower speed for quality or just noise purposes when the wife is in the office, but the printer usually hangs the print for around 2 seconds before continuing. This is quite bad as during these 2 seconds the nozzle stays on the model and usually leaves a blob of plastic where it stayed paused.

I never had my problem on my old Tevo Tarantula (running RepRap) as it allowed me to change the print speed to any percentage with the knob without anything hanging.

Anyone with the same issue? Did you find out a solution?

 

[Epsylon3]

Indeed, when you select "Stable (50%)" this pause is not present, but Silent mode does that.... so i select Stable during first layer and silent later.

Silent may be faster (70%) than stable (50%) but not 100% sure.