Hi,
I've printed a few successful objects using a K1C. This week I've updated the software to 5.1 and exported a complex model (100MB GCode). At first the printer failed after ~20mins with E:2000/unknown command. This is really really terrible product design, the printer should not even attempt to print that file, instead of failing half-way. I've upgraded the firmware, which has fixed that particular error. Now I'm getting E:2560/communication with main MCU failed.
It is very obvious the error is due to the microcontroller being heavily overloaded, so much that pressing the "light-switch" button takes 5+ seconds to switch the lights.
Is there any upgrade to look forward to, which fixes this? Otherwise, whats the point of having a 220x220x250mm print volume when filling it to less than 10% already causes the MCU to halt?
After resuming from E:2560, I'm getting E:2000 unknown exception.
I think I'll return this product.
I've printed a few successful objects using a K1C. This week I've updated the software to 5.1 and exported a complex model (100MB GCode). At first the printer failed after ~20mins with E:2000/unknown command. This is really really terrible product design, the printer should not even attempt to print that file, instead of failing half-way. I've upgraded the firmware, which has fixed that particular error. Now I'm getting E:2560/communication with main MCU failed.
It is very obvious the error is due to the microcontroller being heavily overloaded, so much that pressing the "light-switch" button takes 5+ seconds to switch the lights.
Is there any upgrade to look forward to, which fixes this? Otherwise, whats the point of having a 220x220x250mm print volume when filling it to less than 10% already causes the MCU to halt?
After resuming from E:2560, I'm getting E:2000 unknown exception.
I think I'll return this product.